Understanding the use of electronic products, many people may have concerns when installing and operating them, fearing that these products are more prone to failure. However, this worry is often unnecessary, as these products typically undergo rigorous testing and validation, ensuring high reliability. By focusing on a few key details, installation can be completed easily.
If you purchased a smart toilet from Giving Tree Home, you may refer to this guide for installation. Additionally, your package includes detailed installation instructions to ensure a smooth and easy operation. If you have any questions, feel free to contact our customer service team for assistance. For those who prefer a visual guide, this article also provides a complete installation video to help you get started effortlessly.
Required Tools:
- Screwdriver
- Wrench
- Marking Pen
- Tape Measure
- Caulking Gun
- Electric Drill
Installation Diagram:
WARNING
- Please ensure that the chosen power outlet is properly grounded according to local electrical codes.
- The power cord should be 1.5 meters long. The outlet location should be easily accessible for installation and maintenance, while also maintaining a safe distance from the bathtub area.
- It is strongly recommended to select a waterproof outlet suitable for wet or damp locations.
- Avoid using extension cords to connect this product, as this can lead to fire hazards or electrical shock.
Failure to adhere to these instructions could result in serious safety risks.
Pre-Installation:
Before installing a smart toilet, you need to conduct a water pressure test and flush the pipes to ensure good flushing performance and prevent sediment and impurities from affecting future use. The specific process is as follows:
- Connect the water supply valve and place an empty bucket nearby.
- Open the valve and check if the water flow exceeds 1.32 gallons within 15 seconds.
- Continue flushing for 1 minute to clear any residual impurities in the pipes.
Install the Flange Plate:
The package does not include flange plates; you will need to purchase them separately.
- Place the flange plate into the drainage hole, aligning the arrow on the flange plate with the dashed line on the vertical wall.
- Use a marker to mark the positions of the four installation holes on the flange plate.
- Use an electric drill to create four 6mm installation holes, then insert four corresponding plastic anchors.
- Secure the flange plate in place using the provided screws.
- Insert the T-bolts into the flange, and place the plastic gasket.
Set up the Toilet
- Lift the toilet seat from the toilet.
Note: When lifting the toilet seat, do so carefully from the inside and avoid pulling too forcefully.
- Place a flange ring under the toilet.
- Insert the T-bolts into the ceramic lock screw holes, place flat washers on the T-bolts, and then tighten them with nuts.
- Install the toilet seat onto the toilet body by aligning the locating holes on the seat with the locating pins on the ceramic body. Then, firmly press down on the back of the seat with both hands in a horizontal position to ensure the holes are securely seated onto the pins.
Install Angle Valve
- Insert the water-saving insert and flat gasket into the 1/2-inch-to-3/4-inch adapter.
- Screw the 1/2-inch-to-3/4-inch connector into the angle valve and connect the angle valve to the copper pipe.
- Apply a circle of anti-mold sealing silicone at the junction between the toilet and the floor. After the silicone sealant has cured, plug in the power and slowly open the angle valve. Adjust the water pressure to be within 80 PSI and inspect the seals at all connection points.
Ending
Lastly, it should be noted that this tutorial is applicable to the smart toilets from Giving Tree Home. If you have purchased a different brand, it is best to seek assistance from the corresponding brand.
Related Articles:
